Some progress on F10. I've mounted and primed most of the parts. My estimation was correct and there were just over 100 parts to mount. I've used Tamiya grey primer for all non red and not while parts. For red/white parts Zero white primer was used. Zero white primer goes on in very thin layers. But it is somewhat thick and it seems even 0.5mm nose on my airbrush is still not wide enough. Resulted surfaces from spraying Zero white primer are a bit rough and will require additional smoothing with sand paper. In turn Tmaiya's grey primer goes on quite smooth and parts are pretty much ready for semi-gloss black and Alclad shades. Below are pictures before primer and after.